If your Truck has had the steering gear box changed and the sector shaft diameter measures ~1-1/2"-1-5/8" you will need ZOND8404 also with your kit.
This truck was produced using rear axles of differing diameters; measure the diameter of your rear axle to ensure proper kit selection in configuration.
Factory wheels fit when paired with factory / original equipment tire size.
This kit is not designed for dually models, but may me easily adapted to accommodate your truck. Please contact customer support and they will help you find a solution.
Gas Engine? Gas models may sit slightly taller than the advertised lift height due to lighter weight of engine.
Kit includes a 3" rear block kit. Measure your truck before ordering to determine the stance of your truck with the lift installed.
Two-piece rear drive shaft? Add a carrier bearing drop kit to reduce post-lift driveline angles and avoid / eliminate driveshaft vibration.
Features & Benefits
100% bolt-on design for easy installation.
Bump stop extensions properly limit up-travel, protecting your vehicle.
Heavy-duty upper and lower control arms improve strength and articulation while correcting caster.
Heavy-duty front track bar bracket correctly positions front axle under vehicle.
Steering components included to ensure smooth post-installation operation of steering system and factory-consistent vehicle handling characteristics.
Important NotesIf your Truck has had the steering gear box changed and the sector shaft diameter measures ~1-1/2"-1-5/8" you will need ZOND8404 also with your kit.
This truck was produced using rear...
Important NotesIf your Truck has had the steering gear box changed and the sector shaft diameter measures ~1-1/2"-1-5/8" you will need ZOND8404 also with your kit. This truck was produced using rear...
Important NotesIf your Truck has had the steering gear box changed and the sector shaft diameter measures ~1-1/2"-1-5/8" you will need ZOND8404 also with your kit.
This truck was produced using rear...
Important NotesIf your Truck has had the steering gear box changed and the sector shaft diameter measures ~1-1/2"-1-5/8" you will need ZOND8404 also with your kit.
This truck was produced using rear...
Important NotesIf your Truck has had the steering gear box changed and the sector shaft diameter measures ~1-1/2"-1-5/8" you will need ZOND8404 also with your kit. This truck was produced using rear...