Although rare, some models with 1-piece rear driveshaft may require rear driveshaft spacer kit to ensure sufficient spline engagement.
Will not fit Raptor models.
This kit is offered with either 4" or 5" rear lift block kit and in either case it will replace the factory rear blocks. The 5" block will net a level to slightly tail high stance, the 4" block will net a level to slightly tail low stance. Choose rear lift height based on your ride height preference.
Power steps? If your vehicle is equipped with factory power steps, it will require E-Brake Relocation Bracket. Add in configuration / checkout.
Two-piece rear drive shaft? Add a carrier bearing drop kit to reduce post-lift driveline angles and avoid / eliminate driveshaft vibration.
Wheels / Tires:
Aftermarket 18" or larger wheels required with this kit.
Follow recommended wheel/tire specifications to ensure proper fitment and minimize the need for trimming.
Features & Benefits
High-strength, 1/4" steel construction crossmembers correct lower control arm geometry.
High-pressure, extended length, replacement front struts improve performance on and offroad.
Important NotesAlthough rare, some models with 1-piece rear driveshaft may require rear driveshaft spacer kit to ensure sufficient spline engagement.
Will not fit Raptor models.This kit is offered...
Important NotesAlthough rare, some models with 1-piece rear driveshaft may require rear driveshaft spacer kit to ensure sufficient spline engagement. Will not fit Raptor models.This kit is offered...
Important NotesAlthough rare, some models with 1-piece rear driveshaft may require rear driveshaft spacer kit to ensure sufficient spline engagement. Will not fit Raptor models.This kit is offered...
Important NotesDoes not fit diesel models.Does not fit Tremor models.Requires frame bracket modificationSome trucks with a 2-piece drive shaft may have a recall from Ford regarding the rear drive...
Important NotesE-Brake relocation bracket may be necessary if running stock wheels. Will not fit Raptor models. Wheels / Tires: E-Brake relocation bracket may be necessary if running stock wheels...
Important NotesThis kit is offered with either 4" or 5" rear lift block kit and in either case it will replace the factory rear blocks. The 5" block will net a level to slightly tail high stance, the...
Important NotesWill fit models with Auto 4wd that do NOT have the 4WD actuator hub assembly
Some trucks with a 2 piece drive shaft may have a recall from Ford regarding the rear drive shaft. (Safety...
Important NotesCheck Alignment Cams: 1997-2003 F150's frequently did not include alignment cams, which are necessary to properly align the vehicle. Make sure to add if lifting your vehicle.Axle side...