This kit is offered with either 4" or 5" rear lift block kit and in either case it will replace the factory rear blocks. The 5" block will net a level to slightly tail high stance, the 4" block will net a level to slightly tail low stance.
Choose rear lift height based on your ride height preference.
Power steps? If your vehicle is equipped with factory power steps, it will require E-Brake Relocation Bracket. Add in configuration / checkout.
Two-piece rear drive shaft? Add a carrier bearing drop kit to reduce post-lift drive-line angles and avoid / eliminate driveshaft vibration.
Wheel and Tire:
May require bumper or fender trimming depending on wheel and tire choice. See installation instructions for more information.
Important NotesAccommodates factory 20" wheels with stock tires.Features & BenefitsHigh strength crossmembers to correct lower control arm positioning. Ductile iron steering knuckles to corect...
Important NotesThis kit is offered with either 4" or 5" rear lift block kit and in either case it will replace the factory rear blocks. The 5" block will net a level to slightly tail high stance, the...
Important NotesAccommodates factory 20" wheels with stock tires.Features & BenefitsHigh strength crossmembers to correct lower control arm positioning. Ductile iron steering knuckles to corect...
Important NotesAWD models will require front driveshaft modification.
If using 18x9 wheels with 5.5" backspace, fit the wheels before mounting to check for proper tie rod clearance. Wheel...
Important NotesAlthough rare, some models with 1-piece rear driveshaft may require rear driveshaft spacer kit to ensure sufficient spline engagement. Will not fit Raptor models.This kit is offered...