If your Truck has had the steering gear box changed and the sector shaft diameter measures ~1-1/2"-1-5/8" you will need ZOND8404 also with your kit.
This truck was produced using rear axles of differing diameters; measure the diameter of your rear axle to ensure proper kit selection in configuration.
Diesels Only! Lift springs are designed for heavier diesel models only. Using lift springs with lighter gas models may cause excessive lift and is NOT recommended.
Although rare, if you experience front drive-line vibration, install the optional transfer case indexing ring.
This kit is not designed for dually models, but may me easily adapted to accommodate your truck. Please contact customer support and they will help you find a solution.
Two-piece rear drive shaft? Add a carrier bearing drop kit to reduce post-lift drive-line angles and avoid / eliminate driveshaft vibration.
Adding larger-than-stock wheels? Add front bumper spacers to your kit for additional clearance as some wheel / tire combos may not fully clear the bumper's stock location.
Features & Benefits
100% bolt-on design for easy installation.
High-strength control arm relocation brackets correct suspension geometry and add rigidity.
Important NotesIf your Truck has had the steering gear box changed and the sector shaft diameter measures ~1-1/2"-1-5/8" you will need ZOND8404 also with your kit.
This truck was produced using rear...
Important NotesIf your Truck has had the steering gear box changed and the sector shaft diameter measures ~1-1/2"-1-5/8" you will need ZOND8404 also with your kit. This truck was produced using rear...
Important NotesIf your Truck has had the steering gear box changed and the sector shaft diameter measures ~1-1/2"-1-5/8" you will need ZOND8404 also with your kit.
This truck was produced using rear...
Important NotesIf your Truck has had the steering gear box changed and the sector shaft diameter measures ~1-1/2"-1-5/8" you will need ZOND8404 also with your kit.
This truck was produced using rear...
Important NotesIf your Truck has had the steering gear box changed and the sector shaft diameter measures ~1-1/2"-1-5/8" you will need ZOND8404 also with your kit.
This truck was produced using rear...